The Studio2 1x10 Combo

Same  as The Studio2 Head, but avail­able as a  1x10 Combo.

This full fea­tured (no sim­ple vol­ume and tone con­trol here) 2 watt amp is a record­ing and small venue dream. Its tone, feel and vol­ume are far big­ger than the out­put power rat­ing would have you believe. Being affec­tion­ately coined as hav­ing “Bober Watts”, this amp, as stated by many who have played it, “could cover most small gigs”.  Hav­ing a full com­pli­ment of tone and level con­trols, the sound pal­let of this amp is quite exten­sive. With the right pair­ing of gui­tar, the pos­si­bil­i­ties range from the rel­a­tive clean of the British “H” amps (think Pete Town­shend) to the liq­uid legato of your favorite play­ers of the infa­mous “D” amps, to tones so aggres­sive they might be tug­ging on the shirt­tails of Metal!  The amp also sports an inter­nal load so that it can be run sans speaker. This will allow a sig­nal from the vari­able line out, which is post out­put stage, to be sent to a larger amp via its effects loop return jack or even front panel input. This enables you to repro­duce the full tone of the amp, includ­ing out­put tubes, at what­ever power require­ment is necessary.

Images:

Fea­tures:

Front Panel:

  • Input
  • Gain (pre-volume)
  • Vol­ume
  • Tre­ble
  • Mid­dle
  • Bass
  • Pres­ence
  • Mas­ter
  • Play/Rest switch
  • Power switch

Rear Panel:

  • Effects Send & Return (pas­sive series loop)
  • Speaker out (opti­mized for 8 ohm, but will run 4 or 16)
  • Line Out
  • Level (con­trols level of line out)
  • Clean / Mean switch (con­trols response of out­put stage)
  • Fuse / AC Mains input

Under the Hood:

  • 1– 5U4 rectifier
  • 3– 12AX7 pre­amp tubes
  • 2– 12AT7 out­put tubes (in a push-pull configuration)
  • 2 Watts @ 8 ohm

Phys­i­cals:

  • 23Wx12Dx21H
  • 37 lbs

Click here to down­load the Manual

The man­ual is in .pdf for­mat.  Click the link below to down­load Adobe .pdf Reader

Comments are closed.